Teradek Cube Reference Guide User Manual
Page 13
Version 2
Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 13
Livestream Configuration
3.1. To enable Live Internet streaming, first
launch Cube‟s configuration page by Clicking “Configure
Settings” in TeraCentral.
3.2.
If the wizard appears, click „Skip the Setup Wizard,‟ then log in to Cube‟s web UI. Navigate to
„Video Setup‟ -> „Stream settings.‟
3.3. Under General
/ Type, select „Live Internet Streaming.‟
3.4. Enter your Livestream username, password, and channel short name. Click
„Verify Login‟ to
check that Cube can contact Livestream and that your login information is valid. NOTE: the
channel short name is case sensitive.
3.5. Check any options you would like to apply to your channel. Please refer to the Stream Modes
section for more information on these options.
3.6. Click
„Apply.‟
3.7. Once the settings have been applied, you can start or stop your broadcasts by clicking the
„Start/Stop Broadcast‟ button, or by holding the „Go Live!‟ hardware button on Cube for
approximately 1 second (ENC LED blinks to indicate when Cube is starting/stopping).