Connect to cube using teracentral – Teradek Cube Reference Guide User Manual
Page 9
Version 2
Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 9
2.1. Connect video and power to your Cube Encoder (see Connect and Power Your Device, page
2.2. Connect Cube to your computer via Ethernet.
2.3. Launch TeraCentral
(included on the USB drive), and click the „Configure Settings‟ button next to
your Cube‟s listing. Your browser will open to Cube‟s setup wizard.
2.4.
Click „Next‟ and then „Configure Wireless Interface.‟
2.5.
Select „Infrastructure Mode,‟ wait for Cube to scan for available wireless networks, and select
your access point‟s SSID.
2.6. Enter the network password, if applicable. Click OK.
2.7.
Click „Apply New Network Settings,‟ Cube will join your network.
2.8. Verify that the WiFi LED turns green after applying. You can now disconnect the Ethernet cable
and connect your computer to the chosen wireless network.
Connect to Cube using TeraCentral
1. Launch TeraCentral from the included USB stick, or install TeraCentral on your computer and run the
application.