Teradek Cube Reference Guide - Manual (Page 5)

Version 2 Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 5
Connect and Power Your Device
1. Getting started:
1. To power your Cube, connect the included AC adapter (or accessory power cable, sold
separately) to Cube via the 4 pin LEMO connector marked „6-28 DC Input‟ (b) . Cube begins to
boot as soon as power is connected. NOTE: The ENC/DEC LED blinks to indicate Cube is
booting. This process takes approximately 1 ½ minutes.
2. Connect your video source to Cube via BNC cable (e) (SD/HD-SDI 1xx models, Composite 5xx
models) or HDMI cable (2xx models).
3. Attach the antenna (a) (if applicable) via the threaded RP-SMA connector.
4. Use the i ncluded hot shoe mount and/or ¼” screw (f) to mount Cube to your camera, tripod
mount, or other accessory mount, if desired.
5. Once Cube has booted, verify that the „ENC‟ and „VID‟ LEDs are green, indicating video is
successfully detected (c) .
For more information about Cube‟s physical connections and power options, please see the following
sections.
2. Physical connections:
Left: Cube 1xx SDI encoder, Right: Cube 2xx HDMI encoder
Left: Cube 3xx SDI decoder, Right: Cube 4xx HDMI decoder