Teradek Cube Reference Guide - Manual (Page 26)

Version 2 Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 26
2.3.2. Advanced/Manual Configuration – If your network restricts Cube‟s service advertisements
or if streaming over a WAN or the Internet, manual configuration of the Cube decoder may
be necessary. The manual configuration panel also contains options for adjusting Cube‟s
latency settings. Note that after manually configuring your decoder settings and clicking
„Set,‟ you will still need to click „Apply‟ for the configuration to take effect.
2.3.3. Stream Type: RTP
2.3.3.1. Stream Protocol: Select UDP or TCP. Default is UDP. UDP streaming requires
less network overhead but does not guarantee that video data will arrive intact. TCP
streaming ensures data will arrive at its destination, but requires more network
overhead and may impact performance and delay when bandwidth is limited.
2.3.3.2. Host IP Address: Your encoder‟s IP address.
2.3.3.3. Port: Default is 554, this should not be modified.
2.3.3.4. Stream Name: Choose „Stream1‟ for the main stream or „quickview‟ if enabled
(see Stream Modes, page 15).
2.3.3.5. Audio Channel Mode: Choose Stereo or Mono, depending on the encoder‟s
audio input.
2.3.3.6. Audio Sample Rate: Choose 48kHz if audio is enabled on the decoder, choose
„No Audio‟ otherwise.
2.3.3.7. Latency Options – Caching: Set this equal to or greater than the encoder‟s
caching value. Default is 300ms. See Encoder Controls (page 18) for more
information.
2.3.3.8. Intra Refresh: Set this to „Enabled‟ if your encoder is using Intra Refresh mode.
3. System
3.1. Licenses – Cube supports a variety of features that are activatable on a per-device basis. More
details regarding activatable features and license keys can be found in Advanced and/or