Teradek Cube Reference Guide - Manual (Page 34)

Version 2 Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 34
5.5.1. Decoder Configuration
5.5.2. Select „Manually Configure‟ on the Video Setup ->Decoder Settings page (see page 24).
5.5.3. Stream Protocol: Select UDP or TCP. This value should match the value configured on your
encoder. UDP streaming requires less network overhead but does not guarantee that video
data will arrive intact on lossy networks. TCP streaming ensures data will arrive at its
destination, but requires more network overhead and may impact performance when
bandwidth is limited.
5.5.4. Port: Select the port configured on the encoder. Default is 9710.
5.5.5. Audio Chann el Mode: Choose Stereo or Mono, depending on the encoder‟s audio input.
5.5.6. Audio Sample Rate: Choose 48kHz if audio is enabled on the decoder, choose „No Audio‟
otherwise.
5.5.7. Audio Codec: Select the same value configured on the encoder, either AAC or MPEG2.