Clarinet Systems EthIR LAN - Manual (Page 22)

3-2
Switch via infrared through an EthIR Beam to the Switch (see page 3-3, “Connectivity
Choices for Using the CSI Configuration Tool”).
CSI Configuration Tool Installation
Your EthIR LAN system comes with a CSI Media Installer CD-ROM. On a PC,
insert the CD-ROM into the drive and follow the on-screen prompts. This installs the
Configuration Tool and icons onto your PC.
CSI Configuration Tool Functions
The Configuration Tool provides the following functions:
1. Sets the IP address of the Switch. This is usually required for the Switch to
support IR/PPP devices, or be managed by SNMP.
2. Finds all the EthIR Switches on the network.
3. Updates the Switch firmware.
4. An IP Editor to configure IP addressing. The IP Editor can change the
Switch’s IP address, Gateway, DNS and Proxy server IP addresses, and a pool
of IP addresses. It can also be used to point to a DHCP server on the network
to obtain these addresses.
The following graphic illustrates the Configuration Tool once it is started.