Clarinet Systems EthIR LAN - Manual (Page 25)

3-5
The following steps describe how to set the IP address of the EthIR Switch for the first
time from a notebook running Windows with an enabled Infrared capability:
1. Launch the Infrared applet in the Control Panel to insure that “enable infrared”
is enabled and the “plug and play” feature is disabled.
2. Install the CSI Configuration Tool software on the notebook.
3. Point and EthIR Beam to the notebook’s infrared port.
4. Launch the CSI Configuration Tool.
5. Click the Configure via Infrared.
Models ES208 / 216 / 608
DHCP off. Generic IPs entered DHCP option turned on