Clarinet Systems EthIR LAN - Manual (Page 6)

ii
Software Installation and Hardware Requirements --------------------------------- 2-8
Chapter 3 Configuring EthIR LAN--------------------------------------------------- 3-1
Introduction-------------------------------------------------------------------------------- 3-1
Configure EthIR Switch ----------------------------------------------------------------- 3-1
CSI Configuration Tool------------------------------------------------------------------ 3-1
CSI Configuration Tool Installation -------------------------------------------------- 3-2
CSI Configuration Tool Functions ---------------------------------------------------- 3-2
CSI Configuration Tool Window Description:-------------------------------------- 3-3
Connectivity Choices for Using the CSI Configuration Tool--------------------- 3-3
Configure via Infrared ------------------------------------------------------------------ 3-3
Configure via IP address --------------------------------------------------------------- 3-4
Setting The IP Address Of The Switch For The First Time ---------------------- 3-4
Searching For EthIR Switches --------------------------------------------------------- 3-6
The NVM Editor -------------------------------------------------------------------------- 3-8
General Info Tab ------------------------------------------------------------------------ 3-8
SNMP Variables Tab ------------------------------------------------------------------- 3-9
IP Pool Tab (except ESB3011b)------------------------------------------------------- 3-9
RF Card Info (ESB3011b only) ----------------------------------------------------- 3-10
WEP (ESB3011b only) --------------------------------------------------------------- 3-11
Updating The Firmware --------------------------------------------------------------- 3-12
Switch Security -------------------------------------------------------------------------- 3-12
Chapter 4 ClarinetIR------------------------------------------------------------------ 4-13
APPENDIX A - ------------------------------------------------------------------------------ A-1
Installing Infrared Support for Windows 95 --------------------------------------- A-1
Binding TCP/IP Protocol for Notebook --------------------------------------------- A-4
APPENDIX B - ------------------------------------------------------------------------------ B-1
Verifying that Dial-Up Adapter is in your Network Configuration ----------- B-1
APPENDIX C - ------------------------------------------------------------------------------ C-1
Disabling Puma Technology’s IR Communication Software ------------------- C-1
APPENDIX D - ------------------------------------------------------------------------------ D-1
Browsing the Network Neighborhood Windows 95/98 --------------------------- D-1
APPENDIX E - ------------------------------------------------------------------------------ E-1
Upgrading from 115Kbps to 4Mbps Speeds ---------------------------------------- E-1