Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 107)

W A S H S E L E C T I I
Document Number: WS21058 95
Document Title: WSII Operations Manual ver 6.10
Appendix C. Tunnel Mode
Please refer to Section 2.5.8 before proceeding.
The following describes what default configurations are required to set the coin box into
tunnel mode:
Setting up tunnel mode with Start key (Accepts Cash):
1. Using the Wash Interface menu; set tunnel mode to ‘1’.
2. The Wash Select II must be set as follows:
• Wash Upgrade = Disabled (Default Value)
• Relay Stacking = Enabled (Default Value)
• Relay Latching = Pulsed (Default Value)
• Forced Selection = Enabled (Default Value)
T Y P I C A L C U S T O M E R T R A N S A C T I O N I N T U N N E L M O D E :
Customer drives up to Wash Select II, which then after several seconds of having the
proximity sensor activated, plays a greeting message.
Customer enters some form of money. The Wash Select II plays a wash selection message
(messages 3-6). Included at the end of the wash selection message the message should be
recorded to say ".... Please press the start button to begin your wash."
This message will be repeated every 30 seconds until the Start Button is pressed.
The Wash Select II generates no signals at this time (relays P1-P8 are open).
The customer presses the “Start” button.
Message 12 plays. During setup, it should be recorded to play: "Please place your car in
neutral, roll up your windows and wait for the conveyer to start your wash" (note: you can
change or re-record this message if needed).
After pressing the Start button, the programmed output relays are activated momentarily
(pulsed on for 8 – 10 seconds, then off). The customer screen is then reset to the “Idle
Greeting” screen after 20 seconds.