Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 80)

W A S H S E L E C T I I
Document Number: WS21058 68
Document Title: WSII Operations Manual ver 6.10
The wash is now ready. Please drive in slowly following the entrance sign on the car
wash.
13) EXACT CHANGE ONLY (5 seconds)
Please use exact change only.
14) ADD MONEY NOW (6.75 seconds)
Please add payment for your selection
15) SELECT WASH TYPE (6.75 seconds)
Please Select Soft-cloth or Touch-free now.
16) BAD CARD READ (5.75 seconds)
Your card could not be read. Swipe your card again, or try another card.
17) ENTER PIN (3.25 seconds)
Please enter your PIN number.
18) ENTER DATA (3.25 seconds)
Please enter the requested information.
19) NETWORK ERROR (4.25 seconds)
Sorry, we were unable to process your transaction at this time.
20) SELECT CREDIT/DEBIT (3.25 seconds)
Please select Credit or Debit.
21) ONE MOMENT PLEASE (2.50 seconds)
One moment please.
22) BAD CARD ORIENTATION (5.75 seconds)
Please check your card orientation, stripe to the right.
23) CREDIT TERM CUSTOM (5.00 seconds)
(Customized Credit Terminal Decline Message)
24) SELECT AN OPTION (3.25 seconds)
Please select an option.
When you are ready to record you messages, follow the steps below.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “Speech” option is displayed. Press the (*) key to enter.
3. Scroll through the "Speech" menu until "Record Message" is displayed, then
press (*) to enter. Enter the number of the message you want to record and press
the (*) key to enter.
4. Plug the provided microphone into the top of the speech board.