Unitec Wash Select II With WashPay Integration Operations Manual User Manual
Page 114
W A S H
S E L E C T
I I
Document Number:
WS21058
102
Document Title:
WSII Operations Manual ver 6.10
9.
If you are still having problems, go to the Diagnostics main menu, and choose
“test modem” command. If the modem responds with an OK message, try to
open a batch again.
10.
If you are unable to do so at this point, then you might have a modem with the
wrong programming. If you have the printer option, then go the “credit systems”
menu, and choose “print trans hist” command. Check the printout to see the
reason of the failure.
11.
If you have any clues from the printout, proceed to open the batch after solving
the problems.
12.
If you are still experiencing problems, modem might be bad.
13.
When it is time for you to close a batch (which must be after some transactions by
your customers), go to setup mode. From the setup mode, select “credit
systems”. Then choose “close batch”. Batch should close.
14.
After closing a batch, you should open another batch for your next business
cycle.
2. To Automatically Open/Close Batch:
1.
Go to the setup menu, by turning the setup/operate switch to setup.
2.
Go to “Misc. setup” main menu.
3.
Select the “system time” sub menu and set the time to the current standard time.
4.
From the setup menu, go to the “Credit systems” main menu.
5.
Select “processor type” and set it to 1.
6.
From the Credit Menu, select Set Autobatch and enable it.
7.
Go to the “open batch” command under “Credit systems”.
8.
Batch should open. If so, skip to step 15.
9.
If batch doesn’t open, cycle power to the entry stand, and try to repeat the batch
opening process.
10.
If you are still having problems, check if the modem is powered. Also, check if the
modem cable is well connected. Then, repeat the process.
11.
If you are still having problems, go to the Diagnostics main menu, and choose
“test modem” command. If the modem responds with an OK message, try to
open a batch again.
12.
If you are unable to do so at this point, then you might have a modem with the
wrong programming. If you have the printer option, then go the “credit systems”
menu, and choose “print trans hist” command. Check the printout to see the
reason of the failure.
13.
If you have any clues from the printout, proceed to open the batch after solving
the problems.
14.
If you are still experiencing problems, please contact Unitec, as your modem
might be bad.
15.
You are now ready to do business via credit. You can return the unit back to
operate mode via the setup/operate switch.
16.
If you, for any reason, change your mind to resort to manual batch
opening/closing, all you have to do is repeat steps 5 and 6 above, setting