Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 72)

W A S H S E L E C T I I
Document Number: WS21058 60
Document Title: WSII Operations Manual ver 6.10
The following steps will assist you when setting Token Values.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “Cash & Tokens” option is displayed. Press the (*) key to
enter.
3. Scroll through this menu until the “Token Value” option is displayed, and then
press the (*) key to enter.
4. Enter the token value in cents format, and then press the (*) key to enter. (If you
would like to set the token value to $.75 for example, you would enter 75, and
then press the (*) key.)
Note:
The token value set will be multiplied by the number of pulses sent by the IDX coin
acceptor.
The steps below will assist you when setting the Max Tokens per customer value.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “Cash & Tokens” option is displayed. Press the (*) key to
enter.
3. Scroll through this menu until the “Max Tokens/cust” option is displayed, and then
press the (*) key to enter.
4. Enter the number of tokens you wish each customer to be allowed to use for a
single purchase, and then press the (*) key to enter.
4.5.4 Programming Dispense Value (for $1 coin dispensing only)
If you want your unit to dispense the dollar coin, the coin-hopper must be modified to
accommodate the larger coin. This is described in Section 4.5.5, below. The dispense value
of the Wash Select II must also be changed to reflect the value of the dollar coin. The default
value for this function is $.25. To change the dispense value, follow the steps below.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “Cash & Tokens” option is displayed. Press the (*) key to
enter.
3. Scroll through this menu until the “Dispense Value” option is displayed, and then
press the (*) key to enter.
4. Enter the dispense value in cents form, and then press the (*) key to enter. (If the
dispense value of the coin is $1.00 this must be entered as 100.)