Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 109)

W A S H S E L E C T I I
Document Number: WS21058 97
Document Title: WSII Operations Manual ver 6.10
Appendix D. Wash Select II/POS4000 Canadian Addendum
This Appendix provides additional information relevant to Canadian Wash Select II units.
A. Configure the Wash Select II Coin Dispenser
Remember that the coin that is dispensed is the one that is diverted by the coin acceptor, and
ends up in the hopper.
1. To dispense the $1 coin:
1. From the SETUP menu, go to “CASH & TOKENS”, and then select “COUNTRY
CODE”.
2. Set COUNTRY CODE to ‘2’.
3. From the “cash & tokens” menu, select DISPENSE VALUE and set it to $1.
2. To dispense Quarters:
1. From the SETUP menu, go to “CASH & TOKENS” and select “COUNTRY
CODE”.
2. Set COUNTRY CODE to ‘1’.
B. Token Setup
You can have up to three different types of site-specific tokens. Unitec sends the coin-acceptor
programmed to accept the Canadian $1 coin, $2 coin and quarters. Programming the unit to take
tokens is up to the site, as every site has its own tokens.
For more tokens, your token values should be an integer-multiple of the lowest-value token. For
example, if your lowest-value token is $1, your second and third token values should be one of
$2, $3, $4, etc. Of course, you wouldn’t program two tokens to have the same value.
You have the option of limiting the number of tokens a customer can use per car wash purchase;
you can do so from the “cash & tokens” menu in the setup mode by setting “max tokens/cust” to
any number you want.
The Wash Select II does not keep an account of the different types of tokens your site may have;
we just show the total value of all the tokens on the accounting report.
C. Disable Quarter Acceptance
To disable the acceptance of quarters:
Note:
You can do this only for the standard Canadian Wash Select II (accepts all quarters, $1
and $2 coins, and tokens).
1. Remove the coin acceptor label that reads “Quarters, $1 & $2 coins, Tokens”
from the front of the door.