Clover Electronics LCD2084 - Manual (Page 34)

Stand-alone DVR Instruction Manual
34
6-4. Power On/Off
6-4.1. POWER ON
On the rear panel:
Turn on the POWER switch on the rear panel (See
Fig.5-2
). The LED on the front panel is lit
when the POWER switch is ON.
By Stand-by Power Mode Button
Press this button on the front panel (See
Fig.5-1
) to turn ON the system when the POWER
(MAIN) switch is turned ON and the Stand-by Power Mode Button is turned OFF.
6-4.2. STAND-BY POWER MODE BUTTON
In order to extend the lifetime of the LCD screen and the backlights inside the monitor, press
the POWER button located on the front panel (See [Fig. 5-1]) to turn OFF if you don’t need
to observe the system for a long time. The system will continue recording when it is in the
recording mode even though the Stand-by Power Mode Button is turned OFF.
6-4.3. POWER OFF
By pressing the Stand-by Power Mode Button:
Press the POWER button on the front panel for 3 seconds and then the POWER OFF
message as shown in [Fig. 6-2] will be displayed on the screen.
▫ Click the OK button to turn the power OFF.
On the remote controller:
Press the POWER button on the remote controller and then the following message will be
displayed on the screen.
[Fig. 6-2 Message of POWER off]