Clover Electronics LCD2084 - Manual (Page 42)

Stand-alone DVR Instruction Manual
42
6-7.4.1. COMMUNICATION BETWEEN MONITOR AND CLIENT COMPUTER VIA INTERNET
▫ This system is normally in listening mode between the LCD monitor and your computer
through the Internet (DvrMaster or Internet Explorer). In order to communicate between
the system and your computer, connect a head phone or a microphone and a speaker to
the computer. Adjust the Speaker and the Microphone volume on the DvrMaster or
Internet Explorer by clicking the amount of volume (See section 8-4.8 Speaker /
Microphone).
▫ Don’t forget to turn the AUDIO (speaker) ON by clicking the SPEAKER icon (See section
6-7.4 for more information) on the system.
6-7.4.2. COMMUNICATION BETWEEN MONITOR AND CAMERAS
▫ Turn the AUDIO (speaker) ON by clicking the SPEAKER icon on the LIVE AUDIO pop up
screen. (See 6-7.4 for more information).
▫ To communicate (two way Audio) with a camera, select one out of Indoor cameras by
clicking the CHANNEL button on the LIVE AUDIO pop up screen and press the TALK
button on the side of the system.
▫ To listen only (one way Audio), select one out of outdoor/outdoor cameras by clicking the
CHANNEL button on the LIVE AUDIO pop up screen.
Note :
- It is impossible to communicate between the system and the cameras as long as
the DVRMaster (GUI) is being executed, even though the Speaker and the
Microphone are turned Off.
- Exit the DVRMaster by clicking the Exit button on the GUI in order to communicate
between the system and the cameras.
- In order to listen to the recorded audio in playback mode, select the
corresponding channel to make it a full screen.