Wing alignment – Great Plains YP2425A Operator Manual User Manual
Page 112
108
YP2425A
Great Plains Manufacturing, Inc.
401-626M
2014-02-10
Wing Alignment
To check and adjust wing alignment:
1.
Unfold planter. See “Unfolding the YP2425A
Planter” on page 24. Lower planter. Pull forward.
Refer to Figure 140 and Figure 141
2.
Select a common reference point that is easy to
access at the wing-end and center section end row
units, such as the back of the press wheel
assembly
. On a twin-row planter, align using only
the rear units.
3.
Check for proper alignment by running a string line
across back of planter toward outer ends of wings.
For proper alignment, outside ends of wings
should be 0 to
1
⁄
4
inches ahead of inside ends of
wings at center section
.
4.
To adjust wing alignment, shorten or lengthen eye
bolts
to change the length of the wing pull bar.
Adjust eye bolts in or out until dimension
is
0 to
1
⁄
4
inches (6.4 mm) greater than dimension
.
5.
Be sure both wings are adjusted equally or the
planter will tend to pull sideways behind the tractor.
Figure 140
Alignment Reference Point
25193
1
Figure 141
Wing Alignment
25497
4
3
2
2
3
4
1
2
3
4
2
3