Great Plains YP2425A Operator Manual - Manual (Page 20)

16 YP2425A Table of Contents Index Great Plains Manufacturing, Inc.
401-626M Table of Contents Index 2014-02-10
Electrical Hookup
Refer to Figure 5 (which depicts the North American lighting
connector
and the seed monitor connector )
Your YP2425A Planter is equipped with standard and
optional devices that require separate electrical
connections.Make sure tractor is shut down with
accessory power off before making connections.
These connections may be made in any order.
Note: The switch control module should be mounted in
your tractor cab in a location with easy access.
Route wiring harnesses with enough slack to allow
for tractor movement, especially on articulating
tractors.
Hitching with 3-Point
Refer to Figure 6
4.
Connect your tractor 3-point to the planter 3-point
hitch. If using quick hitch be sure planter locks into
hitch securely.
5. Raise tractor 3-point just enough to relieve pressure
off of the parking stand.
6. Store 3-point stands . There are two methods:
a. Remove lower pins . Swing stand under hitch.
Reinsert pin beneath stand at inner hole.
b. Remove both pins. Invert stand. Re-pin.
Load Sway Hazard:
Adjust 3-point hitch arms and sway blocks to minimize any
side-to-side sway to assure proper tracking in the field, and
safe road travel.
7. Remove and store main tongue parking stand. See
“Store Main Parking Stand” on page 18.
8. Adjust the top link of a 3-point long enough so the
ball swivel does not bottom out when fully raised.
9. Secure hoses so they do not get caught in ball
swivel. Failure to do so could cause hose to be
crushed requiring hose replacement.
Figure 5
Connector Identification
25236
25237
1
2
1 2
Figure 6
3-Point Hitch Stands Stored
29732
4 3
3
4