Raising planter, Lowering planter, Raising planter lowering planter – Great Plains YP2425A Operator Manual User Manual

Page 31

Advertising
background image

Great Plains Manufacturing, Inc.

Table of Contents

Index

Operating Instructions

27

2014-02-10

Table of Contents

Index

401-626M

Raising Planter

Refer to Figure 27
1.

If the planter has hydraulic hitch, set the Lift/Hitch
switch

to LIFT.

Note: If the planter has the standard 3-point hitch, this

switch has no function. The hydraulic circuit is
always in Lift (Raise/Lower) mode.

2.

Move the cab lever to Extend the circuit for Lift/Hitch.

3.

Move lever to Neutral (not Float) to hold at lift.

Machine Damage Risk:
On tractors with electronic timer controls for hydraulic
circuits, lift timers must be set to no more than 2 seconds
longer than needed to fully raise planter.

Do Not Set for Continuous Mode.

For transport, maintenance or storage, install lift cylinder
locks. See “Lift Cylinder Lock-Up” on page 30.

Lowering Planter

Refer to Figure 28

1.

If lift cylinder locks are installed, first fully raise the
planter, and remove the locks. See “Raising
Planter
” on page 27
and Lift Cylinder Lock-Up” on
page 30.

2.

If equipped with hydraulic hitch, set the Lift/Hitch
switch

to LIFT. On 3-point hitch, this switch has no

function and the circuit is in Lift mode at all times.

3.

Move the cab lever to Retract the circuit for Lift/Hitch.
When fully lowered, return lever to neutral.

Machine Damage Risk (Hydraulic Hitch Only):
Never lower planter while fully folded, if it is equipped with
the hydraulic tongue hitch, or machine damage can occur
unless a special procedure is followed (see page 26).
A planter
with a 3-point hitch may be lowered while folded.

Machine Damage Risk:
Never lower planter while partially unfolded (with either
hitch). Wing row units can strike main transport wheels.

1

Figure 27

CFM: Raising Planter

26113

Pinch/Crush Risk:
Keep all personnel clear of center section and seed cart while
raising tool bar. The wheels move inward.

1

1

Figure 28

CFM: Lowering Planter

26113

Crushing Risk:
Keep all personnel clear of center section and seed cart while
lowering tool bar. The wheels move outward.

1

Advertising