Folding, continued – Great Plains YP2425A Operator Manual User Manual

Page 33

Advertising
background image

Great Plains Manufacturing, Inc.

Table of Contents

Index

Operating Instructions

29

2014-02-10

Table of Contents

Index

401-626M

Folding, Continued …

Refer to Figure 31
If caster locks are engaged (wire handle

and

indicator

in FIELD position), they must be released

before folding.

5.

At each wing caster, move the lock control handle
to the ROAD position.

6.

If the indicator end of the lock

does not

immediately snap up from FIELD to ROAD, some
pivot tension is holding the pawl end of the lock

in

the plate detent

. Raise and lower planter fully to

release load on lock plates to allow them to come
open. Move the planter forward or back a short
distance until both locks unlock.

Refer to Figure 32
7.

Set CFM Marker/Fold switch

to Fold. LED above

switch blinks continuously.

8.

Activate (normally Extend) tractor Marker/Fold
hydraulic circuit to fold wings. Sequence begins with
releasing of tongue latch (Refer to Figure 22 on
page 25). Bef
ore folding completes …

9.

Raise planter tongue (“Raising/Lowering Tongue
on page 18). This m
ust be done before folding
completes.

Refer to Figure 33
Note: If tongue is not raised prior to folding complete,

wing locks will be above transport hooks and
unable to secure wings to tongue.

If this happens, partially unfold planter, raise
tongue, and refold.

10. When fully folded, lower tongue so that wing locks

engage transport hooks

.

11. Set CFM Marker/Fold switch

to Marker.

Note: Set switch to marker even if markers are not

installed. This switch position sets the fold and
caster swing arm cylinder solenoid valves off,
providing additional protection against unfolding.

12. Set Marker/Fold circuit lever to Neutral.

13. 3-point: lower hitch completely

Hydraulic tongue: Set hitch circuit to Float (not
Neutral).

Transport Hazard:
Wing locks must be engaged for safe transport, and planter
tongue must be lowered to keep wings locked.

Hydraulic tongue, if installed, must be in Float.

Caster locks must be disengaged for transport.

Figure 31

Caster Unlocked

29306

4

5

7

6

4

5

4

5

6

7

3

Figure 32

CFM: Wing Folding

26033

3

8

9

Figure 33

Wings Locked

26037

8

9

9

8

3

Advertising