Amico Falcon Combo Arm - Manual (Page 16)

16 Amico Accessories Inc.
(Figure 1) (Figure 2)
Monitor Mounting: VESA 75/100
WARNING Ensure that the AHM is in the highest vertical position and locked before mounting or removing
devices from the FIT Station.
NOTE See page 25 for instructions on locking and unlocking the AHM
NOTE 4 x M4 screws are provided for mounting the monitor to the VESA Head, different screws may
be needed if the provided screws are not the right size, standoffs may be needed depending on the hole pattern
on the monitor.
1. Determine the monitor mounting configuration. VESA 75 (75 mm x 75 mm M4 thread) or VESA 100 (100 mm x
100 mm M4 threads).
2. VESA 100 configuration: Partiall 2screws are partially threaded into the top 2 holes in the back of the monitor.
The monitor can then be hung up on the VESA Head through the two slots at the top. Insert 2 more screws
through the VESA-100 mounting holes at the bottom and tighten all screws (Figure 1).
3. VESA-75 configuration: Rotate the VESA Head so the 2 slots for the VESA-75 configuration are located at the top.
Partially thread two screws into the top 2 holes in the back of the monitor. The monitor can then be hung up on
the VESA Head through the two slots at the top. Insert 2 more screws through the VESA-100 mounting holes at
the bottom and tighten all screws.
4. When removing the Monitor, the monitor arm and the monitor should be placed at the highest position (Figure
2). Remove the 2 bottom screws from the VESA plate, loosen the top 2 screws, and lift the monitor off the VESA
plate.
SECTION 3: Device Installation
Front of the VESA 75/100
M4 mounting
hole for VESA-75
M4 mounting
hole for VESA-100