Amico Falcon Combo Arm - Manual (Page 26)

26 Amico Accessories Inc.
Height Locking Lever Adjustments: FIT Station
WARNING The height locking lever must be installed properly before mounting the AHM to the rail or
mounting the monitor to the AHM.
WARNING Never attempt to move the arm vertically without loosening the lever. It will create excessive
force on the AHM and may lead to premature failure.
NOTE: The height locking lever is designed to inhibit all vertical movement of the AHM when it is in
use. Loosen the lever to adjust the AHM vertically, and tighten when finished to lock the AHM in place.
NOTE: Check to make sure the arm is locked in its highest position before mounting the arm into the
channel
1. Insert the height locking lever into the mounting hole on the side of the arm (Figure 1). Turn the lever clockwise
to lock vertical movement, or turn the lever counterclockwise to release the vertical lock. (Figure 2)
SECTION 4: Adjustments
(Figure 1) (Figure 2)
Height Locking Lever:
Rotate Counter-
Clockwise to Release
Rotate Clockwise to Lock