B&G Zeus Touch 12 - Manual (Page 61)

60 |
The echosounder | Zeus Touch Operator Manual
The fish echoes
You can select how you want the echoes to appear on the echosounder image.
Traditional fish echoes Fish symbols and depth indication
StructureScan™ overlay
When a StructureScan unit is connected to your Zeus Touch system, you can
overlay a DownScan image on the regular echo image.
When activated as described below, the echosounder menu will expand to
include basic StructureScan options.
Gain for both images can be adjusted as described on “Adjusting color and gain
settings” on page 57.
For more information about StructureScan, see “StructureScan™” on page 62.
The echosounder settings panel
The echosounder source
If you have more than one echosounder on your network, you can select which sounder to
be the preferred source on this Zeus Touch unit.
Network echosounder
You can share the echosounder connected to this Zeus Touch unit on the network
For more information about how to setup echosounders, refer to the separate Zeus Touch
Installation manual.
The ping speed
The Ping Speed controls the rate the transducer transmits into the water. A high ping speed
will make the image move fast on the screen, while a low ping speed will present a longer
history on the screen. The reverberation potentially caused by too high ping speed can cause
interference on the screen.
TVG
Wave action, boat wakes and temperature inversion can cause on-screen clutter near the
surface. The TVG option reduces surface clutter by decreasing the sensitivity of the receiver
near the surface.
Pausing the echosounder
Refer page 58.