B&G Zeus Touch 12 User Manual
Page 98
| 97
GoFree™ Wireless |
Zeus Touch Operatior Manual
Setting up the WIFI-1
1.
Connect the WIFI-1 unit to the Zeus Touch with the Ethernet cable supplied with the WIFI-1
unit
-
The WIFI-1 access point will now be listed in the Zeus Touch menu
-
The
Network name
and
Network key
is the same as found on the sticker on the WIFI-1
unit
2.
Change the
Network name
and
Network key
if required
Setting up multiple WIFI-1 units
On large or metal hulled vessels it may be necessary to connect multiple WIFI-1 access points
to extend the range.
Up to 2 WIFI-1 units can be connected to one Zeus Touch, but only the WIFI-1 unit defined as
primary access point can be used for connecting the wireless device to the Zeus Touch.
3.
Open the access points dialog as shown above
4.
Activate the line for the connected WIFI-1 unit, and re-define this to be a secondary access
point
5.
Connect and define the additional WIFI-1 unit as described in “Setting up the WIFI-1”
-
The latest connected WIFI-1 unit will now be the primary access point, and only this can
be used for connecting the wireless device to the Zeus Touch.
Selecting communication channel
The WIFI-1 unit will automatically select the channel used for communication with the
wireless devices.
You might need to change the channel if other transmitting devices cause conflicts (multiple
networks, wireless phones etc), or if you are using the equipment in areas with restricted
channel selection.
The channels can be manually changed from the drop down list.
¼
Note:
Only technically skilled persons should set up multiple WIFI-1 units or change the
communication channel!