Baseline Systems BaseManager 2.0 - Manual (Page 17)

Assigning Mainlines (BaseStation 3200 Controller)
1. In the main BaseManager interface, select the site and controller that you want to assign a mainline to.
a. From the list under the All tab on the left side of the map, click the site. The controllers assigned to that
site are listed below the site name.
b. Click the controller that you want to work with. A blue arrow displays next to the controller that is
selected.
2. Click the Water Sources tab, click Mainlines, and then click the Edit Mainline button.
3. Update the fields as needed, and then click Save.
Assigning Points of Connection (BaseStation 3200 Controller)
1. In the main BaseManager interface, select the site and controller that you want to assign a point of connection
(POC) to.
a. From the list under the All tab on the left side of the map, click the site. The controllers assigned to that
site are listed below the site name.
b. Click the controller that you want to work with. A blue arrow displays next to the controller that is
selected.
2. Click the Water Sources tab, click Points of Connection, and then click the Edit Point of Connection button.
3. Update the fields as needed, and then click Save.
Assigning Points of Connection (BaseStation 1000 Controller)
1. In the main BaseManager interface, select the site and controller that you want to assign a point of connection
(POC) to.
a. From the list under the All tab on the left side of the map, click the site. The controllers assigned to that
site are listed below the site name.
b. Click the controller that you want to work with. A blue arrow displays next to the controller that is
selected.
2. Click the Programs tab, and then click the row for the program where you want to assign a point of
connection.
3. Expand the Point of Connection Assignments section, and then perform any of the following tasks:
• To assign a water source, click the Add Water Source button, and then select the water source that you
want to assign to this program.
• To assign a master valve, click the Add Master Valve button. Click the arrow in the master valve list, and
then select the master valve that you want to assign to this program.
4. Click the Save button on the end of the program row.