Cooper Instruments & Systems DFI INFINITY B Ultra High Performance Digital Force Indicator - Manual (Page 11)

BUTTON Function in Configuration Mode
Firmware Version Number and only after applying the power. Use ‘▲/MAX’ to select “MENU 2” or “MENU
1” the default modern Menu Navigation option. Press ‘MENU’ button again to store your Menu selection.
If "MENU 2" is selected, users will be prompted to choose one of these three available Display
Colors: "GREEN", "AMbER" or "REd".
• Use this button to advance/navigate to the next menu item. The user can navigate through all the top-level
menus by pressing “MENU” repeatedly.
• While a parameter is being modified, press this button to escape without saving the parameter.
• Press this button to access the submenus from a Top Level Menu item.
• Press this button, to store a submenu selection, or after Entering a selected value/state - the display will
flash a “StOREd” message to confirm your selection.
• In Menu Configuration Mode, pressing this button repeatedly also allow user to sequence and confirm all
settings through entire setup menu items.
• In the Run Mode, pressing the ‘RESET/ENTER’ button once erases the memories of Peak “HI RdG”, Valley
“LO RdG” reading values, and Alarm Latches. The display shows “RESEt 1” momentarily then returns to
Run Mode.
• In the Run Mode, pressing ‘RESET/ENTER’ button twice, will cause a hardware reset, as display shows
“RESEt 2”.
• Reset: Except for Set Points and the Alarms, modifying any settings of the menu configuration will reset
("RESEt 2") the unit prior to resuming Run Mode.
• Every Menu underlined item, number, or state is the Factory default/preset value. Example: 001, 002, 004
• Make certain that the unit has no locked menu before attempting to locate and configure the specific menu
function.
CF 156 6 M2544/N/0505