Cooper Instruments & Systems DFI INFINITY B Ultra High Performance Digital Force Indicator - Manual (Page 10)

Figure 4-1. Front Detail
ITEM
DESCRIPTION
1 or
6-digit, 9 segment, alphanumeric 0.68” high LED display with programmable decimal point.
2 SETPOINT LED
These LEDs, labeled 1 through 4, display the status of setpoints.
1 (Setpoint 1)
2 (Setpoint 2)
3 (Alarm 1)
4 (Alarm 2)
3 UNIT OF DEGREE LED
These LEDs, labeled
o C, o F, and o K display the status in Celcius, Fahrenheit or Kelvin.
4 5 Pushbuttons
BUTTON Function in Configuration Mode
• This button functions only in Run Mode. When the Setpoint/Alarm features are unlocked, pressing this
button sequentially recalls the previous setpoint settings to the display. After the ‘►/MIN’ and ‘▲/MAX’
buttons are used to alter those values, as desired, pressing the ‘SETPTS’ button again, stores these new
values.
• At any step within this Setpoint Settings Mode, each of the four setpoint values are displayed for
approximately 10 seconds after the last press of any of the ‘SETPTS’, ‘►/MIN’ and ‘▲/MAX’ buttons.
• Press the up ‘▲/MAX’ button to scroll through "flashing" selections. If the function requires a numerical
value to be entered and displayed, press this key to increase value of a parameter that is currently being
modified. The " - " Minus sign will be available at the first digit from left side of display.
• In the Run Mode, pressing the ‘▲/MAX’ button causes the display to flash the PEAK “HI RdG” Reading
value – press again to return to the Run Mode.
• Press the ‘►/MIN’ button to go back to a previous Level Menu item, or Run Mode if the last menu was one
of Main Menu items.
• Press this button twice to back up further to the Main Menu item (Main Menu) or Run Mode, if the last menu
was the submenu of the Main Menu item, in Menu Configuration Mode.
• Press this button three times in Menu Configuration Mode as necessary to reset the controller to the Run
Mode.
• When a numerical value is flashing, press this button to step through digits from left to right, allowing the
user to select the desired digit to modify. If all digits are not flashing and decimal point is, press ‘▲/MAX’ to
select decimal point position to display it (or even without decimal point appearance due to the nature of
LED display in the last operation).
• In the Run Mode pressing the ‘►/MIN’ causes the display to flash the VALLEY “LO RdG” reading value -
press again to return to the Run Mode.
• To enter the Menu, the user must first press ‘MENU’ button.
• To select
“older -style” of Menu Configuration, “MENU 2”, press ‘MENU’ button while Display is showing
CF 156 5 M2544/N/0505