Yealink W52P - Manual (Page 29)

Basic Operations
17
To configure basic network settings manually:
1. Press to enter the main menu.
2. Select ->System Settings->Network.
3. Enter the system PIN (default: 0000).
4. Press the Done soft key.
5. Press or to select Static from the IP Address Type field.
6. Enter the valid values in the IP Address, Subnet Mask, Default Gateway, Primary
DNS and Secondary DNS fields respectively.
7. Press the Save soft key to accept the change.
Static DNS is not normally required when DHCP is enabled on your phone. In some
cases, static DNS may be needed in your environment. Then you can manually
configure static DNS on the handset to ignore DNS obtained by DHCP.
To configure static DNS:
1. Press to enter the main menu.
2. Select ->System Settings->Network.
3. Enter the system PIN (default: 0000).
4. Press the Done soft key.
5. Press or to select Manual from the DNS Type field when DHCP is selected from
the IP Address Type field.
6. Enter the valid values in the Primary DNS and Secondary DNS fields respectively.
7. Press the Save soft key to accept the change.
If you are using an xDSL modem, you can connect your base station to the Internet via
PPPoE mode. Set the Internet port as a PPPoE port. The PPPoE port will perform a PPP
negotiation to obtain the IP address. Contact your system administrator for the PPPoE
user name and password.
To configure PPPoE:
1. Press to enter the main menu.
2. Select ->System Settings->Network.
3. Enter the system PIN (default: 0000).
4. Press the Done soft key.
5. Press or to select PPPoE from the IP Address Type field.
6. Enter the valid values in the PPPoE User and PPPoE Password fields.
7. Press the Save soft key to accept the change.
Note Using wrong network settings may result in inaccessibility of your phone and may also
have an impact on your network performance. For more information on these
parameters, contact your system administrator.