Yealink W52P - Manual (Page 63)

Call Features
51
To un-mute a call:
1. Press again.
The icon disappears from the LCD screen.
You can place an active call on hold. At any time, at most one active call can be in
progress on your handset. Another call can be answered and made while placing the
original call on hold.
To place a call on hold:
1. Press the Options soft key during a call, and then select Hold.
The call is placed on hold and the icon is displayed on the LCD screen.
To resume a hold call:
Do one of the following:
- Press the Resume soft key.
- Press .
- Press .
Two calls on Hold:
If two calls are placed on hold on the handset, press the Resume soft key to resume the
current call. Press
, or the Swap soft key to swap between two calls.
Note
You can enable or disable call waiting feature on the handset. If call waiting feature is
enabled, the handset will notify you of a new incoming call during a call, and present
the incoming call information visually on the LCD screen. You can also enable the
handset to play a warning tone when receiving a new incoming call during a call. If call
waiting feature is disabled, the new incoming call will be automatically rejected by the
handset.
To configure call waiting feature:
1. Press to enter the main menu.
2. Select ->Call Waiting.
3. Press or to select the desired value from the Status field.
When the call on the handset is placed on hold, placing the handset in the charger
cradle will not end the call.