Dick SM-100 230V - Manual (Page 56)

SM-100 belt grinder 20
Putting into operation
7
1
Undo the fastening screws [2] of the right-hand side
panel [1],
2
push the right-hand side wall [1] to the rear and remove,
3
turn the grinding belt by hand, at the same time checking
whether it drifts to the side,
4
if necessary, use the adjusting screw [3] so that the belt runs
in the middle of the deflection pulley.
5
Screw the side panel back on tight.
6
If necessary, readjust while the motor is running.
Adjusting the grinding arm angle
The angle of the grinding arm can be adjusted before working with
the belt grinder. Adjust the angle as follows:
1
Undo the adjusting screw [1],
2
Move the grinding arm into the required position,
3
Tighten the adjusting screw [1].
Figure 7.5 –
Grinding arm angle
[1]
Adjusting screw
1