FORD 2013 Explorer v.3 - Manual (Page 197)

Clearing a HomeLink ா device
To erase programming from the three HomeLink
௡ buttons, press and
hold the two outer HomeLink
௡ buttons until the indicator light begins to
flash. The LED will begin flashing in 10 to 20 seconds, at which time
both buttons should be released. Programming has now been erased, and
the led should blink slowly to indicate the device is in train mode when
any of the three HomeLink buttons are pressed.
FCC and RSS-210 Industry Canada Compliance
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications to your device not expressly approved by the
party responsible for compliance can void the user’s authority to operate
the equipment.
196 Universal Garage Door Opener (If Equipped)
2013 Explorer (exp)
Owners Guide gf, 3rd Printing
USA (fus)