System errors, Switching the systems off and on, Collision warning system (if equipped) – FORD 2013 Taurus v.2 User Manual

Page 238: Collision warning system, 238 driving aids

Advertising
background image

System Errors

If either system senses a problem with the left or right sensor, the BLIS

indicator in the information display will illuminate and remain on. Also,

BLIND SPOT SYSTEM FAULT

or

CROSS TRAFFIC SYSTEM

FAULT

message will appear. When problems that may cause the left or

right indicator not to illuminate, only the information display message
faults appear.

Switching the Systems Off and On

One or both systems can be switched off temporarily by using the
information display control; refer to the

Information Display

chapter.

When the BLIS

is switched off, the driver does not receive alerts and

the information display shows BLIND SPOT SYS OFF and/or CTA
SYSTEM OFF. The system switches back on whenever the ignition is
switched on.

One or both systems can also be switched off permanently at your
authorized dealer. Once switched off, switching it back on must also be
done at the dealership.

COLLISION WARNING SYSTEM (IF EQUIPPED)

WARNING:

This system is designed to be a supplementary

driving aid. It is not intended to replace the driver’s attention,

and judgment, or the need to apply the brakes. This system does NOT
activate the brakes automatically. Failure to press the brake pedal to
activate the brakes may result in a collision.

WARNING:

The collision warning system with brake support

cannot help prevent all collisions. Do not rely on this system to

replace driver judgment and the need to maintain distance and speed.

Note:

The system does not detect, warn or respond to potential

collisions with vehicles to the rear or sides of the vehicle.

Note:

The collision warning system is active at speeds above

approximately 5 mph (8 km/h).

238

Driving Aids

2013 Taurus
Owners Guide gf, 2nd Printing
USA

(fus)

Advertising