Iris Sample Processing StatSpin® CenSlide 2000 Urine Sediment Analysis System - Manual (Page 12)

Operation
OPERATOR’S MANUAL
CenSlide 2000 Urinalysis System Page 2 - 4
2.6 Centrifuge Operation
1.Press the green “START”
button on the control panel
of the CenSlide 2000
Centrifuge (Figure 2.4).
The amber “CYCLE” light
will flash, indicating that the
centrifuge is currently in
operation.
Microprocessor technology is used to monitor the speed and
time to assure accuracy. Near the end of the cycle, a flicking
process (clicking sound) will automatically occur to evenly
disperse the sediment in the CenSlide tube.
2. At the end of the cycle, an audible beep will sound, the
amber “CYCLE” light will go out, the green “READY” light
will begin blinking and when the rotor stops, the lid will
automatically open.
Note: If the "OPEN/ABORT" button is pressed during
operation, the centrifuge will stop. The amber "CYCLE" light
will flash slowly and a beep will sound to indicate interruption
of the cycle. When the rotor stops, the lid will automatically
open. It is recommended that the samples be discarded.
Figure 2.4
For safety purposes, the lid will not open
while the rotor is turning.