Conair CTS 7 - Manual (Page 12)

The Conair CTS Saw is an on- or off-line sawing device capa-
ble of both on-demand and continuous cutting.
Conair CTS Saws can cut extrudable plastics and rubber both
on- and off-line. Other extrudable materials-foods, ceramics,
magnets, soaps, etc.-may also be cut depending on specific
application requirements.
CTS Saws are available with different cutting capacities (5, 7,
and 9 inches) to suit your specific needs. The standard saw
orientation is right-to-left, saws can also be made with a left-
to-right orientation (see Specifications in this section). (The
illustrations in this User Guide represent the standard right-to
left configuration.)
CTS saws are limited to a specific range of product sizes
based on each unit's cutting capacity.
Different materials, line speeds, temperatures and material
cross-sections can result in different cutting torques. If you are
changing any of these parameters, consult your Conair service
personnel to be sure your equipment can handle the changes.
W
HAT IS THE
CTS S
AW
?
CTS Saw UGE058/0803
2-2
D ESCRIPTION
T
YPICAL
A
PPLICATIONS