Conair CTS 7 - Manual (Page 69)

Appendix B-1 (13)
Cycles Softkey
Pressing the soft key located under the word Cycles on the
P/M area screen, selects the machine cycles screen.
The Machine Cycles screen displays the total cycles that
the machine has completed. This information could be used
for scheduling preventive maintenance. The displayed total
can not be reset.
Exit or Prev- Pressing Exit, Prev or the Softkey under the
word Exit returns the display to the P/M area screen.
T a b l e S o f t k e y
Pressing the soft key located under the word Table on the
Maint area screen. Selects the Table area screen. Two table
travel direction sub-menus, Return and Advance can be
displayed.
Exit or Prev- Pressing Exit or Prev returns the display to
the Maint area screen.
Conair Servo
Traveling Saw
Operator Control
Instructions
M A C H . C Y C L E S 0 0 0 0 0 0 0 0
E x i t
S E L E C T D I R E C T I O N
R e t u r n A d v a n c e