Conair CTS 7 - Manual (Page 50)

CTS Saw UGE058/0803
6-4
T
ROUBLESHOOTING
E
LECTRICAL
P
ROBLEMS
Look in this section when you have problems such as lights on
the control that are working improperly, buttons that do not
execute the function properly, and when information input is
not executed properly.
Symptom
◆
Saw will not
start
◆
Saw blade runs
backwards
Possible cause
The E-stop button is
depressed.
Motor overload tripped
Disconnect in the off posi-
tion.
AC Power is phased
incorrectly for your plant
Solution
Make sure the E-stop is
extended.
Reset motor overload.
Turn disconnect to the on posi-
tion.
Change the wire on the plug to
match your plants AC phasing.