Canon VK-64 - Manual (Page 121)

121
4
Registering
Camera
Ser
ver
and
S
etting
Recor
ding
Sc
hedule
Setting Motion Detection Recording
The Motion Detection Options field also allows you to set the sensitivity for Motion
Detection within the Active Region.
Motion detection status is shown by the Detection Indicator during operation.
Detection Indicator Colors
Motion is displayed in the Detection Indicator as a green color bar and will remain green if the
level of motion is below the set Sensitivity and within a defined Area Ratio. If motion reaches
the set Sensitivity and Area Ratio, the color bar changes to yellow and if the detected motion
remains at the yellow level for the defined duration, a red color bar is displayed and an event is
triggered. The behavior of the Detection Indicator is described as follows.
Green color bar - The area of change that is less than the
specified Area Ratio, i.e., activity remains at the left of the Area
Ratio marker.
Yellow color bar - The area of change that is equal to or greater
than the specified Area Ratio (activity peaks on or to the right of
the Area Ratio Marker) but the required amount of motion has
not met the specified duration in order to trigger an event.
Red color bar - The amount of change that meets the defined
detection conditions and motion is detected, triggering an event,
i.e., the required amount of motion has been detected for the
specified duration.
Area Ratio marker.
Area Ratio marker.
Area Ratio marker.
Area Ratio slide bar.
Area Ratio marker.