Dell C7765DN MFP Color Laser Printer - Manual (Page 612)

23 Problem Solving
612
003-311
003-318
003-319
003-320
003-321
003-322
003-323
003-324
003-325
003-326
003-327
003-328
003-329
003-330
003-331
003-332
003-333
003-334
003-335
003-336
003-337
003-338
003-339
003-340
003-341
003-342
003-343
003-344
003-345
003-346
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
003-700 [Cause] Too many documents are set in the document feeder after clearing the paper jam.
[Remedy] Check the output, and then replace the documents that have not been copied yet.
003-702 [Cause] You tried to copy sides 1 and 2 of a document simultaneously specifying different
Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703 [Cause] The Calibration Chart is not detected correctly.
[Remedy] Place the Calibration Chart properly.
003-704 [Cause] An error is found in the calibration pattern read, and the machine may be out of order.
[Remedy] Execute the calibration again. If the error is not still resolved, contact Customer Support
at dell.com/contactdell.
003-705 [Cause] Copying is started before the machine exits the Power Saver mode and detects the
change for the tray size, when the paper size set in the tray that has been changed during
the Power Saver mode.
[Remedy] Cancel copying, and perform the operation for copying again.
003-750 [Cause] Unable to store any documents using the 2 Sided Book Copying feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "Layout Adjustment" (P.94).
Status Code Cause and Remedy