Dell 3130cn Color Laser Printer - Manual (Page 117)

Printer Maintenance
The Printer Maintenance tab includes the System Settings, Paper Density, Registration Adjustment, Adjust
Altitude, Reset Defaults, Non-Dell Toner, Initialize PrintMeter, Tray Setting, TCP/IP Settings, and Network
Settings pages.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
System Settings
Purpose:
To Use these settings to configure the printer's power management, warning tones, time-out time, operator panel
language setting, job log auto print, position of the Print ID, setting of the dump print, setting of the additional memory,
setting of the substitute sheet, mm/inch setting, and duplex print settings.
Values:
Power Saver
Timer Mode 1*1
5-60 Min.
Specifies the time before the printer enters the power saver timer mode
1(sleep mode) after it finishes a job.
5 Min.*
Power Saver
Timer Mode 2*1
1-6 Min.
Specifies the time before the printer enters the power saver timer mode 2
(deep sleep mode) after it finishes a job.
6 Min*
Audio Tones
Control Panel
Tone
Off* Does not emit a tone when the operator panel input is correct.
On Emits a tone when the operator panel input is correct.
Invalid Key
Tone
Off* Does not emit a tone when the operator panel input is incorrect.
On Emits a tone when the operator panel input is incorrect.
Machine
Ready Tone
Off* Does not emit a tone when the printer becomes ready.
On Emits a tone when the printer becomes ready.
Job Complete
Tone
Off* Does not emit a tone when a job is complete.
On Emits a tone when a job is complete.
Fault Tone
Off* Does not emit a tone when a job ends abnormally.
On Emits a tone when a job ends abnormally.
Alert Tone
Off* Does not emit a tone when a problem occurs.
On Emits a tone when a problem occurs.
Out of Paper
Alert Tone
Off* Does not emit a tone when the printer runs out of paper.
On Emits a tone when the printer runs out of paper.
Low Toner
Alert Tone
Off* Does not emit a tone when toner or some other consumable is low.
On Emits a tone when toner or some other consumable is low.
Base Tone
Off* Does not emit a tone when the operator panel display is returned to the
default settings by scrolling the loop menu.
On
Emits a tone when the operator panel display is returned to the default
settings by scrolling the loop menu.
Fault Time-Out
0 Disables the fault time-out.
3-300 sec
Specifies the amount of time the printer cancels for a job stops
abnormally.
60 sec*
Time-Out
0 Disables the job time-out.
5-300 sec
Specifies the amount of time before the printer cancels for jobs that stop
abnormally.
30 sec*
English*