Installation step 2, Install the header bracket – Craftsman 139.53920D User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION STEP 2
Install the Header Bracket
You can attach the header bracket either to the wail
above the garage door, or to the ceiling. Follow the
instructions which will work best for your particular
requirements
Do not install the header bracket
over drywail. ft installing into masortry, use
concrete anchors {not provided).
WALL HEADER BRACKET INSTALLATION
* Center the bracket on the vertical centerline with
the bottom edge of the bracket on the horizontal
line as shown (with the arrow pointing toward the
ceiting)
• Mark the veiticaf set of bracket holes,. Drill 3/16"
pilot holes and fasten the bracket securely to a
structural support with the hardware provided..
waw Mount
Mounting Hofes
CEILING HEADER BRACKET INSTALLATION
• Extend the vertical centerline onto the ceiling as
shown.
» Center the bracket on the vertical mark, no more
than 6" (15 cm) from the wall. Make sure the arrow
is pointing away from the wall. The bracket can be
mounted flush against the ceiling when clearance
is minima!,,
• Mark the side holes. Drill 3/16" pilot holes and
fasten bracket securely to a structural support with
the hardware provided.
— Finishod Celtmg
Cefifng Mounting Holes
13