Craftsman 139.53920D - Manual (Page 29)

mmsrmmmT
stei » 3
Test the Safety Reversal System
TEST
• With the door fully open, place a 1-1/2" (3,8 cm}
board (or a 2x4 laid flat) on the floor, centered
under the garage door
» Operate the door in the down direction. The door
must reverse on striking the obstruction
ADJUST
• if the door stops on the obstruction, it is not
traveling far enough in the down direction
increase the DOWN limit by turning the DOWN
limit adjustment screw counterclockwise 1/4 turn
NOTE: On a sectional door, make sure limit
adjustments do not force the door arm beyond a
straight up and down posiiiom See the illustration
on page 2S,
• Repeat the test.
• When the door reverses on the 1-1/2“ (3,8 cm)
board, remove the obstruction and run the opener
through 3 or 4 complete travel cycles to test
adjustment
• if the unit continues to fail the Safety Reverse Test,
call for a trained door systems technician-
IMPORTANT SAFETY CHECK;
Test the Safety Reverse System after;
• Each adjustment of door arm length, limits, or
force controls,,
• Any repair to or adjustment of the garage door
(including springs and hardware).
• Any repair to or buckling of the garage floor.
• Any repair to or adjustment of the opener
A
WARNING
Without a properly Installed safety reversal system,
persona (particuiarly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door
• Safety reversal system MUST be tested every morith.
• If one control (force or travel limits) Is adjusted, the
other control may also need adjustment
• After ANY adjustments are made, the safety reversal
system MUST be tested. Door MUST reverse on
contact with 1-1/2“ high (3 8 cm) object (or 2x4 laid
flat) on the floor
AD«BUSTMENT STEP 4
Test The Protector System^
• Press the remote control push button to open the
door.
• Place the opener carton in the path of the door.
• Press the remote control push button to close the
door. The door will not move more than an inch
(2.5 cm), and the opener lights will flash.
The garage door opener will not close from a remote
if the indicator light in either sensor is off (alerting
you to the fact that the sensor is misaligned or
obstructed).
If the opener closes the door when the safety
reversing sensor is obstructed (and the sensors
are no more than 6" (IS cm) above the floor), call
for a trained door systems technician.
AWARNING
Without a properly installed safety reversing sensor,
persons (particutarly stnall children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
Safety Heuewing Swsor Safety Reversing Sensor
29