Craftsman 139.53920D - Manual (Page 35)

PROeilAMMINe
NOTICE: If this Secuhtyi^garage door opener is operated with a non-rolling code transmitter, the technical
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-hetd remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security^'® remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON
1 Press and release the “learn"
button on the motor unit The
learn indicator light will glow
steadily for 30 seconds
2. Within 30 seconds, press and
hold the button on the hand­
held remote* that you wish to
operate your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light buibs
are not installed, two clicks will
be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote.
first erase all codes:
m m
Press and hold the “learn” button on
P
o
motor unit until the learn indicator ................
light goes out {approximately B seconds). Ail previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use
*3-Function Remotes
It provided with your garage door opener, the large
button is factory programmed to operate It, Additional
buttons on any
Securlty+® 3-Funclion
remote or compact
'
remote can be
programmed to operate
other Securityi*® garage
door openers.
35