Craftsman 139.53920D - Manual (Page 36)

To Adtif Eepmgram or Chang® a Keyless Entry PIM
MOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE “LEARN” BUTTON
Ta change an existing, krrown PIN
|{ the existing PIN is known, it may be changed by
one person without using a iadder.
1, Press the four buttons for the present PIN, then
press and hold the # button
The opener light will blink twice Release the #
button,,
2. Press the new 4-digit PIN you have chosen, then
press Enter.
The motor unit lights will blink once when the PIN
has been learned.
Test by pressing the new PIN, then press Enter, The
door should move.
To set a temporary PIN
You may authorize access by visitors or service
people with a temporary 4-digit PIN, After a
programmed number of hours or number of
accesses, this temporary PIN expires and will no
longer open the door, it can be used to
close the
door even after it has expired. To set a temporary
PIN:
1. Press the four buttons lor your personal entry PIN
{not the last temporary PIN), then press and hold
the i|5 button.
The opener light will blink three times. Release the
button.
2. Press the temporary 4-digit PIN you have chosen,
then press Enter.
The opener light will blink four times.
3. To set the number of hours this temporary PIN will
work, press the number of hours (up to 255), then
press ik.
OR
3. To set the number of times this temporary PIN will
work, press the number of times (up to 25S), then
press
The opener light will blink once when the temporary
PIN has been learned.
Test by pressing the four buttons for the temporary
PIN, then press Enter. The door should move. If Ihe
temporary PIN was set to a certain number of
openings, remember that the test has used up one
opening,To clear the temporary password, repeat
steps 1 “3, setting the number of hours or times to 0
in step 3.
1. Press and release the "learn”
button on motor unit. The learn
indicator light will glow steadily
for 30 seconds.
2 Within 30 seconds, enter a four
digit personal identification
number (PIN) of your choice on
the keypad. Then press and
hold the ENTER button.
3. Release the button when ihe
motor unit lights blink, it has
learned the code. If light bulbs
are not installed, two clicks will
be heard-
One Button Close
Opener can be closed by pressing only the ENTER
button if Ihe one button close feature has been
activated- This feature has been activated at the
factory. To activate or deactivate this feature press
and hold buttons 1 and 9 for 10 seconds. The
keypad will blink twice when the one button close Is
active. The keypad will blink four times when one
button close is deactivated.
36