Craftsman 139.53920D - Manual (Page 23)

INSmLLATlON STEP 11
Pastsn the Door Bracket
Follow instruciions which apply to your door type
as illustrated below or on the following page.
A horizontal reinforcement brace should be long
enough to be secured to two vertical supports. A
vertical reinforcement brace should cover the
height of the top panel.
The illustration shows one piece of angle iron as the
horizontal brace. For the vertical brace, two pieces of
angle iron are used to create a U-shaped support
(Figure 1). The best solution is to check with your
garage door manufacturer lor an opener installation
door reinforcement kit.
NOTE: Mmy vertical brace hstallatlons provide for
direct attachment of the clevis pin and door arm.. In
this case you will not need the door bracket; proceed
to installation Step 12..
SECTIONAL DOORS
• Center the door bracket on the previously marked
vertical centerline used for the header bracket
installation. Note correct UP placement, as
stamped Inside the bracket (Figure 2) ,
• Position the bracket on the face of the door within
the following limits:
A) The top edge of the bracket 2”-4’' (5-10 cm)
below the fop edge of the door
8) The top edge of the bracket directly below any
structural support across the top of the door
CAUTION
Fiberglass, aluminum or lightweight steel garage doors
WILL REQUIRE reinforcement BEFORE installation of
door bracket Contact your door manufacturer for
reinforcement kit
* Mark and drill 5/16" left and right fastening holes..
Secure the bracket as shown in Figure 1 if there is
vertical reinforcement
If your installation doesn't require vertical
reinforcement but does need fop and bottom
fastening holes for the door bracket, fasten as shown
in Figure 2