Craftsman 139.53920D User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MOUNTING AND WIRING THE SAFETY
REVERSING SENSORS

• Slide a 1/4“*20x1/2” carriage bolt head into the slot

on each sensor Use wing nuts to fasten sensors to
brackets, with ienses pointing toward each other
across the door Be sure the lens is not obstructed
by a bracket extension (Figure 5)

• Finger tighten the wing nuts.

• Run the wires from both sensors to the opener Use

insulated staples to secure wire to wail and ceiling.

• Strip 1/4" (6 mm) of insulation from each set of

wires. Separate white and white/black wires
sufficiently to connect to the terminal screws; white
to 2 and white/black to 3 (Figure 6).

ALIGNING THE SAFETY REVERSING SENSORS

• Plug in the opener. The indicator lights In both the

sending

and

receiving eyes

will

glow steadily

if

wiring connections and alignment are correct

The

sending

eye amber indicator light will glow

regardless of alignment or obstruction. If the green
indicator light in the

receiving eye

is off, dim, or

flickering (and Ihe invisible light beam path is not
obstructed), alignment is required.

• Loosen the

sending eye

wing nut and readjust,

aiming directly at the

receiving eye.

Lock in place.

• Loosen the

receiving eye

wing nut and adjust

sensor until it receives the sender’s beam. When
the green indicator light

glows steadily,

tighten the

Figure 5

TROUBLESHOOTING THE SAFETY REVERSING
SENSORS

1. If the

sending eye

indicator tight does not

glow

steadily ai\er

inslaiiation, check for:

• Electric power to the opener.

• A short in the while or white/black wires, These

can occur at staples, or at opener connections.

« incorrect wiring between sensors and opener.

• A broken wire.

2

If the

sending eye

indicator light

glows steadily but

the

receiving eye

indicator light doesn't:

• Check alignment

• Check for an open wire to the

receiving eye.

3 , If the

receiving eye

indicator light is dim, reaiign

either sensor.

NOTE: When the invisible beam path is obstructed
or misaligned while the door is closing, the door will
reverse, lithe door is already open, it wHi not close.

The opener lights will blink 10 times. See page 20.

22

Advertising