Craftsman 139.53920D User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
nKfn
nrvnDQ
ICL/Cl LJwv-/riClS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors aiso.
• Center the door bracket on the top of the door, in
line vtfifh the header bracket as shown,- Mark either
the left and right, or the lop and bottom holes,,
* Drill 5/16“ pilot holes and fasten the bracket with
hardware suppiied.,
if the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2'' lag
screws (not provided) to the top of the door,
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dolled line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16'‘x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
24