Canon EOS 50E - Manual (Page 41)

□
I. AF Modes and Metering Modes
p Turn the Main Diai to select a
^ blinking calibration No.
• If none of fhe calibrafion numbers blink
when selected, see “Deleting a Calibration
Setting” on page 45.
0 Look through the viewfinder.
Look at the blinking focusing point
on the right and press the shutter
button.
• The beeper will sound Keep looking at the
right focusing point for 1 to 2 sec until it
stops blinking.
• If the Custom Function has been set to
silence the beeper, the beeper will not
sound during the calibration process (page
78)
Release the shutter button. The left
focusing point wiil then start
blinking. Look at the blinking
focusing point on the left and press
the shutter button. After 1 or 2 sec.,
the beeper will sound. This completes
the horizontal calibration.
• When the calibration is completed, the left
focusing point stops blinking and stays lit.
“End-” is also displayed in the viewfinder
and on the LCD panel
• If you stop the calibration process midway,
wait until the focusing point lit in red in the
viewfinder turns oft. Then press the shutter
button and start from step 3 above
41