Catler FP 8010 - Manual (Page 13)

12
OVERLOAD PROTECTION SYSTEM
If the motor overloads, the food processor
will go to ‘Standby’ mode and “OVERLOAD”
icon in the LCD starts to fl ash. The food
processor can still be switched off by
pressing the POWER/OFF button. To operate
the food processor again, allow the machine
to cool for approx 30 minutes.
Some stiff mixtures, such as dough, may
cause the dough blade to rotate more slowly
than normal. If this happens, do not process
for longer than 1 minute.
If the blades or discs should jam while
processing, ensure the POWER/OFF button
is pressed to switch the motor OFF. Switch
off the power outlet. Remove the processing
lid and adjust any food wedged between
the blade and the bowl or in the disc.
Replace the lid and proceed as normal. If this
occurs again, the processing bowl may be
overloaded, so remove some of the food and
process in smaller batches.
NOTE:
The food processor is designed so the
motor will not operate without the
processing bowl and lid are correctly
locked into position and the pusher
inserted into the feed chute. In the
event that the food processor starts
without the lid correctly locked into
position, immediately disconnect
at the power outlet and return to
your local Catler Service Centre for
examination.
ASSEMBLING YOUR FOOD PROCESSOR FP 8010