Replacing the hood, Replacing the hood -10 – Dynojet 250: Torque Module User Manual
Page 14
Advertising
Torque Module Installation and User Guide for Model 250 Dynamometers
C H A P T E R 1
Load Cell Installation
1-10
R
EPLACING
THE
H
OOD
1
Replace the hood on the dyno leaving it propped up. Secure the key switch, if
present, and connect the battery.
2
Lower and secure the hood using the four bolts you removed earlier.
Figure 1-12: Replace the Hood
3
Secure the hood clamps to the brake using the two bolts you removed earlier.
4
Replace the brake cover and secure using the four bolts you removed earlier.
Figure 1-13: Replace the Brake Cover and Hood Clamps
key switch
brake cover
hood clamps
Advertising