Dynojet 250: Torque Module - Manual (Page 28)

Torque Module Installation and User Guide for Model 250 Dynamometers
A P P E N D I X A
Torque Module Calibration
A-6
While installing the calibration weights, you should notice the Torque Gauge on the
DynoTrac Window moving from 0 to about 500 ft.-lbs. The gauge is for display
purposes only and may not read correctly. The gauge remains uncalibrated until the
calibration process is complete.
Note: Let the torque gauge needle stabilize before clicking Next.
Figure A-8: Torque Gauge
8 From the Span Calibration window (Figure A-6), click Next to continue.
9 Remove the calibration arm and weights and click Finish.
Figure A-9: Calibration Is Complete Window