Dynojet 250: Torque Module - Manual (Page 5)

Torque Module Installation and User Guide for Model 250 Dynamometers
1-1
C
H A P T E R
1
T
ORQUE
M
ODULE
I
NSTALLATION
This document provides instructions for installing and using the Torque Module on
the model 250 dynamometer (dyno) with WinPEP 7. Appendix A includes instructions
for using the Torque Module with WinPEP 6. To ensure safety and accuracy in the
procedures, perform the procedures as they are described.
This chapter will walk you through installing the Torque Module, installing the load
cell, and assembling the calibration arm.
Document Part Number: 98295104
Version 4
Last Updated: 03-09-05
This chapter is divided into the following categories:
• Introduction, page 1-2
• Torque Module Installation, page 1-3
• Load Cell Installation, page 1-6
• Calibration Arm Assembly, page 1-11